HEAT repair clamp ROMACON HEAT repair clamp

The clamps can be used to repair the following pipe types:

  • Ductile Iron (DI)
  • Cast Iron (CI)
  • Steel (St.)
  • Asbestos Cement (AC)
  • PE coated steel
  • PVC*
  • GRP*
  • PE*

* If pipe repair clamps are to be used on plastic pipes, please always contact ROMACON or a ROMACON distributor for more information regarding the application and restrictions on these pipe types.

ROMACON repair clamps should be used under following conditions:

  • The width of the clamp should be at least equal to the pipe OD.
  • The width of the clamp should be 150 mm greater than the length of any crack on pipes with an outside diameter up to 350 mm. On larger pipes this should be at least 200 mm.
  • For PVC pipes, the width of the clamps should be 50 % longer and bolt torque should be reduced by 50 %. We prefer that you consult your ROMACON distributor. 
  • The maximum allowable distance between two pipe ends should not exceed 10 mm.
  • The maximum allowable deflection is 2 degrees.
  • The maximum allowable o!set should not exceed 3 mm.

Material specification:

  • All metal parts: stainless steel AISI 304 or AISI 316L.
  • Metal parts have been deburred and are passivated to restore the corrosion resistance to its original state after the welding process.
  • Single band (one section) with a working range of 7-11 mm depending on the diameter. For an overview of all working ranges please see our price-list.
  • Standard certified rubber gaskets EPDM or NBR. The rubber is tapered and has a waffle pattern.
  • Seamless rubber lining for every clamp diameter.
  • Bridge plates are vulcanized into the rubber gasket.
  • U-shaped lifter bars.
  • Stainless steel, electrolytic zinc plated nuts to prevent galling.
  • Stainless steel washers.
  • No special tools required: a simple wrench will do the job.
  • Special tape is used to fix the rubber gasket to the stainless steel band. This tape is flexible and reinforced with glassfibre thread to withstand hot and humid conditions and guarantee a long storage capability.
  • Under most circumstances the clamps can be installed without releasing the pressure on the pipe.
  • With the clamp's removable closing mechanism you only need 10mm of free space to install the clamp.
  • The clamps are separately packed into strong double-rib cartons. For export overseas we use strong, seaworthy crates.

Pressure ratings:
Pressure ratings for water ** depend on the type of break or damage, pipe OD, medium etc.

  • Pipe DN 40 up to and including DN 150: 16 bar
  • Pipe DN 175 up to and including DN 300: 10 bar

Our clamps can be modified to cope with higher working pressures.

** Please contact ROMACON or your distributor for more information regarding pressures on gas pipes.

Romacon repair clamp type HEAT